Jump to: navigation, search

Cancel Event Block

Use cancel a custom event. You specify the event name and a message, which is selection of a dynamic variable.  It is a terminating block (can end an application instead of an Exit block). Orchestration Server 8.1.2+ versions are required for Raise and Cancel Event blocks.

The Cancel Event block has the following properties:

The Cancel Event block has no page exceptions.

Name Property

Find this property's details under Common Properties for Workflow Blocks.

Block Notes Property

Find this property's details under Common Properties for Workflow Blocks.

Condition Property

Find this property's details under Common Properties for Workflow Blocks.

Logging Details Property

Find this property's details under Common Properties for Workflow Blocks.

Log Level Property

Find this property's details under Common Properties for Workflow Blocks.

Request Id Property

Select the variable containing the request ID.

Enable Status

This property controls whether or not a block contributes code to the application. You may wish to use this property if there is a need to temporarily remove a block during debugging or, for other reasons during development, temporarily disable a block. This saves the effort of having to remove the block and then add it back later.

This page was last edited on July 22, 2013, at 19:16.
Comments or questions about this documentation? Contact us for support!