This page was last edited on April 6, 2020, at 18:30.
Comments or questions about this documentation? Contact us for support!
Outbound Contact Configuration Wizard puts the information about installed Dialogic boards and resources in CME. You can use Genesys Administrator to change the configurations, as needed. See Dialogic Board Configuration Structure.
The following table lists frequently used configurations for Dialogic boards. The driver names are provided for a single board configuration. For multiple boards, the corresponding board numbers must be sequentially numbered.
Board |
Type |
Configuration |
D/160JCT-LS | Virtual Board | 4 LSI (dxxxB1...dxxxB4) |
Virtual Device | 4 channels on each board (dxxxBxC1...dxxxBxC4) | |
Voice Virtual Board | 4 voice (dxxxB1...dxxxB4) | |
Voice Virtual Device | 4 channels on each board (dxxxBxC1...dxxxBxC4) | |
D/41JCT | Virtual Board | 4 LSI (dxxxB1...dxxxB4) |
Virtual Device | 4 channels on each board (dxxxBxC1...dxxxBxC4) | |
Voice Virtual Board | 4 voice (dxxxB1...dxxxB4) | |
Voice Virtual Device | 4 channels on each board (dxxxBxC1...dxxxBxC4) | |
D/480SC-2T1 | Virtual Board | 2 DTI boards (dtiB1, dtiB2) |
Virtual Device | 24 channels (23 if) on each board (dtiBxT1...dtiBxT24) | |
Voice Virtual Board | 12 voice boards (dxxxB1...dxxxB12) | |
Voice Virtual Device | 4 channels on each board (dxxxBxC1...dxxxBxC4) | |
D/300JCT-2E1 | Virtual Board | 2 DTI boards (dtiB1, dtiB2) |
Virtual Device | 30 channels on each (dtiBxT1...dtiBxT30) | |
Voice Virtual Board | 8 voice boards (dxxxB1...dxxxB8) | |
Voice Virtual Device | 4 channels on boards 1 to 7, 2 channels on board 8 | |
DM/V300 | DM3 board with CPD functionality | 30 channels |
DM/V600-2E1 | DM3 board with CPD functionality | 60 channels |
DM/V600BTEPEQ | DM3 board with CPD functionality | 60 channels |
DM/V600BTEPW | DM3 board with CPD functionality | 60 channels |
DM/V960-4T1 | DM3 board with CPD functionality | 96 channels |
DM/V1200-4E1 | DM3 board with CPD functionality | 120 channels |
DM/V1200BTEPEQ | DM3 board with CPD functionality | 120 channels |
DM/V1200TEPW | DM3 board with CPD functionality | 120 channels |
When configuring a DM/V-type board, configure the Dialogic channels similar to the way in which you configure any CPD Server that is operating in Transfer mode and that interfaces with a lineside T1/E1. The following two sections provide more information about configuring specific models of this board type.
Note: | The line-type option must contain a value of line-side-dm3. |
Start If you are using a DMV480A-2T1 board, do the following:
Note: | If you are using a DMV960A-4T1 board, replace ml2_dsa_cas with ml2_qsa_cas. |
End
Start If you are using a DMV480-4T1 board, do the following:
End