DialogicManager_CPD Section

PDF This Page

• BackupTServerAddress
• BackupTServerPort
• CPDCallsByTServer
• CPDFAX2AsAM
• CPDOffHookDelayMsec
• CPDPostConnectPriority
• CPDPreConnectPriority
• CPDTServerCallClear
• CPDTServerConnTimeoutMsec
• CPDWaitOffHook
• PrimaryTServerAddress
• PrimaryTServerPort

     

BackupTServerAddress

Default Value:
Valid Values:
Changes Take Effect: After restart

Specifies the IP address of the backup T-Server.

>> Back to Top

---

BackupTServerPort

Default Value: 0
Valid Values:
Changes Take Effect: After restart

Specifies the port of the backup T-Server.

>> Back to Top

---

CPDCallsByTServer

Default Value: 0
Valid Values:
Changes Take Effect: After restart

If checked, the CPD library will make outbound calls using TServer (not Dialogic).

>> Back to Top

---

CPDFAX2AsAM

Default Value: 0
Valid Values:
Changes Take Effect: After restart

Indicates if CPD library should accept FAX2 tone as Answering machine.

>> Back to Top

---

CPDOffHookDelayMsec

Default Value: 100
Valid Values:
Changes Take Effect: After restart

This parameter is used only if the parameter CPD Calls Made by TServer is selected.Specifies the off-hook delay in milliseconds. A negative value specifies to go off-hook first, wait for the specified time, and then dial a number. A positive value specifies to dial first, wait for the specified time, and then set the channel off-hook.

>> Back to Top

---

CPDPostConnectPriority

Default Value: TServer
Valid Values:
Changes Take Effect: After restart

Indicates if priority should be given to TServer or Dialogic, in case of conflicting CPD results: TServer,Dialogic

>> Back to Top

---

CPDPreConnectPriority

Default Value: TServer
Valid Values:
Changes Take Effect: After restart

Decides the priority between T-Server or Dialogic for Pre-connect CPD events

>> Back to Top

---

CPDTServerCallClear

Default Value: 0
Valid Values:
Changes Take Effect: After restart

Specifies whether outgoing calls are to be cleared by T-Server.

>> Back to Top

---

CPDTServerConnTimeoutMsec

Default Value: 20000
Valid Values:
Changes Take Effect: After restart

Specifies the dialer reconnect timeout for T-Server in milliseconds.

>> Back to Top

---

CPDWaitOffHook

Default Value: 0
Valid Values:
Changes Take Effect: After restart

This parameter is used only if the parameter CPD Offhook Delay has a negative value. If this parameter is selected, the CPD library waits for the off-hook confirmation event from T-Server before dialing.

>> Back to Top

---

PrimaryTServerAddress

Default Value:
Valid Values:
Changes Take Effect: After restart

Specifies the IP address of the primary T-Server.

>> Back to Top

---

PrimaryTServerPort

Default Value: 0
Valid Values:
Changes Take Effect: After restart

Specifies the port number of the primary T-Server.

>> Back to Top

---