Jump to: navigation, search

remdial Section



  


maxcalls

Default Value: 500
Valid Values: The number should be an integer greater than 0 and less than or equal to the maximum integer as defined by the Genesys Administrator Help.
Changes Take Effect: At start/restart


Maximum number of concurrent remdial calls

maxclientsockets

Default Value: 64
Valid Values: The number should be an integer greater than 0 and less than or equal to the maximum integer as defined by the Genesys Administrator Help.
Changes Take Effect: At start/restart


Max number of remdial clients allowed

port

Default Value: 6999
Valid Values: The port number must be an integer from 1030 to 65535 inclusive
Changes Take Effect: At start/restart


Remdial port

telnetmode

Default Value: RAW
Valid Values: Choose between: RAW or NORMAL
Changes Take Effect: At start/restart


Remdial telnet mode. If set to RAW, remdial will buffer data until it receives a carriage return. If set to NORMAL, Remdial will expect the that the full request was sent all at once. RAW is the recommendation configuration since it will support most telnet clients. The default Windows telnet client will only work if this configuration is set to RAW. NORMAL will provide a performance boost if the client sends the full request all at once. Most Linux and Solaris clients, along with PuTTy on Windows, will work with this configuration.

Feedback

Comment on this article:

blog comments powered by Disqus
This page was last modified on 24 July 2017, at 02:04.