Jump to: navigation, search

Starting and Stopping GMS

Overview

You can start and stop Genesys Mobile Services in the following ways:

Objective Related procedures and actions
Using Solution Control Interface (SCI) Complete the following procedure:

Resultset next.png Starting and Stopping GMS Using Solution Control Interface

Using Genesys Administrator Complete the following procedure:

Resultset next.png Starting and Stopping GMS Using Genesys Administrator

Starting and Stopping GMS Applications Using Solution Control Interface

Prerequisites

  • Genesys Mobile Services is installed.

Start

  1. From the Applications view in SCI, select Genesys Mobile Services Application object on the list pane.
  2. Click the appropriate button (Start, Stop, or Stop Gracefully) on the toolbar, or select that command from either the Action menu or the shortcut menu. (Right-clicking your Application object displays the shortcut menu.)
  3. Click Yes in the confirmation box that appears. Your application obeys the command that you selected.

End

For information about how to use SCI, refer to Framework Solution Control Interface Help.

Starting and Stopping GMS Applications Using Genesys Administrator

Prerequisites

  • Genesys Mobile Services is installed.

Start

  1. Log in to Genesys Administrator.
  2. On the Provisioning tab, select Environment > Applications.
  3. Select the GMS Application.
  4. Right-click the application, and then select the appropriate command from the drop-down menu. These three choices apply:
    • Start applications
    • Stop applications
    • Stop applications gracefully

End

Configuring a Delay for Graceful Shutdown

When you select a graceful shutdown, the Solution Control Server (SCS) sends a suspend message to GMS, so that GMS sets itself to OFFLINE. Load Balancer will no longer send requests to this GMS. After a configurable delay, SCS sends a STOP signal, and the GMS will stop. To configure this delay:

Start

  1. In Configuration Manager, select the GMS Application.
  2. On the Annex tab, sml section, set the suspending-wait-timeout to the desired value:
    • Default Value: 10
    • Valid Values: 5-600

End

Feedback

Comment on this article:

blog comments powered by Disqus
This page was last modified on 11 April 2018, at 12:02.