Jump to: navigation, search

Editing dial plan settings

Warning
This Administration Guide applies ONLY to the Legacy SIP Feature Server 8.1.200.xx release. Unless you have been told to use this documentation, use the current 8.1.2 Administration Guide

If your Feature Server installation allows it, you can edit dial plan settings in the Feature Server web application. Otherwise, any dial plan settings you make in the administration web application are not used.

To edit the top-level dial plan settings:

  1. Log into the Feature Server administration Web application as an administrator (<Feature Server IP address>:<port>/fs/admin). Select Dial Plan > Dial Plan Settings.
  2. Ensure that you have created the required calling profiles.
  3. At the bottom of the page, click Edit.
  4. Select a Default Internal Calling Profile to govern what happens when a call arrives from an internal user or DN (including internal remote users). Note that call settings assigned at the user or DN-level take precedence over the value assigned here.
  5. Select an External Caller Calling Profile to govern what happens when a call arrives from an external source.
  6. Configure Outbound Routing Rules to specify the physical route to take for external destinations.
    • Click New to add a routing rule. The rule is a pattern that must match the outbound dialed number; for example, 91XXXXXXXXXX=>${DIGITS} means that all 12-digit numbers (beginning with 91) dial the route groups that you specify in the next step.
    • Under the Groups column, click Add to assign one or more route groups to the routing rule in that row. Add groups in order of priority: the server attempts to route the call through the first route group that you add, then tries the next group until it succeeds. Name the route group and type a prefix that is one or more digits that match the prefix option, which belongs to a SIP Server trunk or trunk group. For example, you can route a call to a trunk with a 54 prefix, or to a trunk group with a us-ip prefix.
    Important
    You must assign at least one trunk to each outbound routing rule.
  7. Configure call settings:
    Setting Values (default value in bold) Description
    Reject Call On Not Ready Off, On Rejects call when a user is not ready on a device.
    Call Waiting On, Off Does not reject a call when the user or device is already in a call.
    No Answer Timeout 30 sec, 5 to 60 seconds (in 5-second intervals) Specifies the length of time, in seconds, that Feature Server waits for the user to answer a ringing call.
    Voicemail Enabled Yes, No Enables calls to be sent to voicemail, if a mailbox exists and if call waiting is off and DND is on.
    Forwarding On No Answer Null (Not Set), Voicemail, <DN> After the No Answer Timeout value elapses, forwards calls to voicemail or to a specified number.
    Forwarding On Busy Null (Not Set), Voicemail, <DN> When the user or device is on a call, forwards calls to voicemail or to a specified number.

    Note: User settings have a higher priority than dial plan settings.

  8. Click Save changes.
This page was last edited on August 21, 2015, at 23:43.
Comments or questions about this documentation? Contact us for support!